Bottle caps
Jewelry pliers
Small flat top cabinet knobs (small enough to fit beneath the caps when they are slightly flared)
ETI EnviroTex(TM) Jewelry Resin (www.ETI-USA.com)
Beacon(TM) 527 Adhesives (www.BeaconAdhesives.com)
Instructions:
1. Use jewelry pliers to slightly bend/flare rim of bottle caps outward to fit over knob.
2. Mix EnviroTex(TM) Jewelry Resin according to manufacturer instructions.
3. Apply a light coat to the face of each bottle cap. Set aside to cure 24 hours.
4. Fill inside of bottle cap completely with Beacon(TM) 527 adhesive.
5. Carefully insert bottle cap over adhesive. Carefully wipe any adhesive that may run out of cap (I used a cotton swab to do this).
6. Let dry 24-36 hours until adhesive is completely dry and cap is adhered to knob.
Original article and pictures take http://www.hometalk.com/11296833/diy-vintage-soda-bottle-cap-cabinet-knobs site
Комментариев нет:
Отправить комментарий