As I chose a 48 SF bed which was 12' long, I needed 3 – 2×12's @ 12' long (pressure treated), a 1x4x12 (pressure treated) for staking the box to the ground & 1 pound of 2 ½" deck screws. If you have an issue with gophers or other digging vermin, you may consider buying some chicken wire that can be placed at the very bottom of the assembly. Depending on the land & garden soil available you may need to buy some soil or compost (up to 36 Cubic Feet to achieve 9" of suitable planting material in the planter.)
Cut one of the 2×12's and the 1×4 into 3 – 4' segments – next cut the 1×4 section in half at a 45 degree angle – you may wish to make one additional cut to make a cut that looks like this ( > ). This will make it easier to pound it straight into the ground.
2 of the cut 2×12 sections are for the ends and the remaining one is for the center – keeping the pieces flush with each other, use three deck screws at each connection point. The 6 stakes, should be pounded into the ground at the 4 outside corners and on each side of the center support.
This post is based off our original one located here: http://blog.sls-construction.com/2010/creating-a-raised-garden-bed
Original article and pictures take http://www.hometalk.com/1149047/creating-a-raised-garden-bed-in-just-a-few-hours site
Комментариев нет:
Отправить комментарий